Framing & Layout

How to Calculate Stair Stringers: Step-by-Step Framing Guide

By Carpentry & Engineering Team • October 18, 2026 • 6 min read
How to Calculate Stair Stringers: Step-by-Step Framing Guide

Calculating and cutting stair stringers is often considered one of the most intimidating tasks in residential carpentry. However, when broken down into logical mathematical steps and proper framing square layout, anyone can produce rock-solid, code-compliant stairs.

1. Measuring the Total Rise Accurately

The Total Rise is the exact vertical distance from the finished upper floor (or deck surface) down to the finished lower landing surface. Do not measure from raw subfloors or unpaved ground—always account for final concrete pavers, decking boards, or finished flooring.

💡 Pro Tip: Place a long, straight 2x4 on the upper deck surface projecting outward, level it with a 4-foot spirit level, and drop a plumb line or tape measure down to where the lowest stringer foot will rest.

2. Core Calculation Formulas

Once you have your Total Rise, follow this mathematical sequence:

  • Step A (Estimate Risers): Total Rise ÷ 7.5 inches (ideal target riser height). Round to the nearest whole integer.
  • Step B (Exact Riser Height): Total Rise ÷ Number of Risers. (Example: 54″ ÷ 7 = 7.714″ or 7-11/16″).
  • Step C (Number of Treads): Number of Risers − 1. (There is always one fewer tread cut than risers because the top deck surface acts as the final step).
  • Step D (Total Run): Number of Treads × Tread Depth (typically 10″ or 11″).
  • Step E (Stringer Board Length): Use the Pythagorean theorem: √(Total Rise² + Total Run²). Add 12–18 inches for safety margins when purchasing 2x12 timber.

3. Selecting Lumber & Using Framing Gauges

Always use #1 or #2 grade pressure-treated 2x12 lumber for exterior deck stringers. Inspect the lumber crown and ensure the crown faces upward. Check along the board edges for large knots where notches will be cut; knots near the cut throat significantly weaken load capacity.

Attach brass stair gauges to your steel framing square:

  • Clamp one gauge on the tongue (narrow arm) at your exact calculated riser height.
  • Clamp the second gauge on the body (wide arm) at your exact chosen tread run.
  • Slide the gauges firmly against the edge of the 2x12 and trace each step sequentially down the timber.

4. The Critical Bottom Riser Deduction

The single most common rookie mistake is forgetting to trim the bottom of the stringer. Because you will be adding tread material (e.g. 5/4 deck board = 1″ thick) on top of every notch, you must cut off the thickness of one tread from the very bottom foot of the stringer. Failing to do this will make your first step one tread thickness too tall and your top step one tread thickness too short!

Need Exact Numbers for Your Project?

Use our free interactive Stair Stringer Calculator to get instant rise and run breakdowns, cut lists, angle calculations, and visual blueprints.

Open Stair Stringer Calculator →

More Trending Guides