How Many Stair Stringers Do I Need? Spacing Guide for Wood & Composite
One of the most frequent structural defects on residential decks is insufficient stair stringer support. When stringers are spaced too far apart, treads flex underfoot, feel spongy, and can split or dislodge over time.
1. The Impact of Tread Material (Wood vs Composite)
The required spacing between your stringers depends primarily on the stiffness of your tread decking material:
- Standard 2x Lumber (2x10 or 2x12 pressure-treated pine, fir, cedar): Maximum allowable spacing is 16 inches on-center. Solid 2x lumber provides superior spanning strength and can support standard foot traffic without noticeable deflection.
- 5/4 Wood Decking (1″ thick nominal boards): Maximum allowable spacing is 12 inches on-center.
- Composite & PVC Decking (Trex, TimberTech, Fiberon): Maximum allowable spacing is strictly 12 inches on-center, with many manufacturers recommending 9 to 10 inches for heavy commercial traffic or diagonal tread patterns. Composite decking softens in high summer heat and will noticeably sag if installed across a 16″ span.
2. Quick Reference Sizing Table
| Total Stair Width | 2x Wood Treads (16″ O.C.) | Composite / 5/4 Boards (12″ O.C.) |
|---|---|---|
| 36 inches (3 ft standard) | 3 Stringers (18″ max span) | 4 Stringers (12″ span) |
| 48 inches (4 ft wide) | 4 Stringers (16″ span) | 5 Stringers (12″ span) |
| 60 inches (5 ft wide) | 5 Stringers (15″ span) | 6 Stringers (12″ span) |
| 72 inches (6 ft grand) | 6 Stringers (14.4″ span) | 7 Stringers (12″ span) |
3. The Calculation Formula
To calculate stringer count mathematically for any arbitrary staircase width:
NumberOfStringers = NumberOfSpans + 1
For example, on a 42-inch wide composite stairway: 42 / 12 = 3.5 spans → rounded up is 4 spans → 4 + 1 = 5 stringers.
4. Additional Construction Best Practices
- Secure with Structural Screws: Use structural wood screws (like FastenMaster TimberLOK or Simpson Strong-Tie SDWS) rather than standard framing nails for stringer-to-rim connections.
- Install Lateral Blocking: Place horizontal 2x4 or 2x6 bridging between intermediate stringers mid-span to prevent twisting and lateral racking.
- Protect End-Grain: Coat all freshly cut stringer notches with copper naphthenate wood preservative to protect against ground-level rot.
Calculate Your Deck Stair Materials
Need lumber estimates, board lengths, and stringer spacing for an outdoor deck? Use our Deck Stairs Calculator.
Open Deck Stairs Calculator →More Trending Guides
How to Calculate Stair Stringers: Step-by-Step Framing Guide
Master the mathematical formulas and practical step-off techniques for calculating total rise, run, riser height, and cutting clean stringer notches with a framing square.
The 7-11 Stair Rule: IRC Building Codes & Riser-Tread Safety
Understand the International Residential Code (IRC R311.7) standards for maximum riser height, minimum tread depth, headroom clearance, and step uniformity.